DieselShip's Online Content Library

Q1. (a) State the factors in the storage of welding electrodes which will assist in producing good quality welds. (2)

(b) Explain the importance of edge preparation before welding. (2)

(c) Sketch TWO methods of plate edge preparation. (2)

(d) A hairline crack is detected in a pipe, as Chief Engineer Officer, state the factors to be taken into account in reaching a decision on the method of repair. (4)

Q1. With reference to machinery parts under cyclic loading, describe, with the aid of sketches, how the propagation of even the smallest of cracks can lead to total component failure. (10)

Q2. (a) Explain EACH of the following control terms:

(i) cascade; (2)                              (ii) split range. (2)

(b) Describe, with the aid of a sketch, a control system that may be enhanced by the inclusion of cascade control. (6)

Q3. With reference to main propulsion shaft systems:

(a) describe a method of hydraulic jacking to check bearing loads; (5)

(b) sketch the Bearing Load versus Shift Lift Dial Gauge Reading graph obtained by the method described in part (a), annotating the graph and how the characteristic of bearing load is obtained. (5)

Q4. (a) State the affinity laws for a centrifugal pump. (3)

(b) State the effects on the pump affinity laws of fitting a slightly smaller diameter impeller. (2)

(c)  Explain, with the aid of a Head versus Flow diagram, why a two speed pump is preferable to throttling where high and low capacities are demanded for a large sea water circulating pump.(5)

Q5. (a) State the regulations pertaining to the main and auxiliary steering gear with reference to EACH of the following:

(i) rudder angle and time of operation;(2)

(ii) electrical supply. (3)

(b) With reference to a hydraulic steering gear, explain EACH of the following:

(i) the factors that may contribute to the failure of a hydraulic pipe coupling; (2)

(ii) what is meant by the single failure concept. (3)

Q6. (a) Sketch a diagrammatic arrangement of a fully automatic direct expansion domestic refrigeration system which supplies a number of cold rooms. (5)

(b) State, with reasons, FIVE desirable thermodynamic properties of a refrigerant. (5)

Q7. With reference to automatic sprinkler systems for fire fighting purposes:

(a) explain, with the aid of a Heat Release versus Time diagram, the difference between fire control and fire suppression; (6)

(b) state the limitations of using glass bulbs to activate sprinkler heads and suggest, with reasons, an alternative mechanism. (4)

Q8. Following bunkering operations, it is discovered that the vessel received a quantity which was short of what was stipulated in the pre-delivery document.

As Chief Engineer Officer, write a Note of Protest to the Master of the bunkering vessel. (10)